MATERIAL SAFETY DATA SHEET MSDS 0224 ============================================================================= Section 1 -- PRODUCT AND COMPANY IDENTIFICATION ----------------------------------------------------------------------------- HMIS CODES PRODUCT NAME Health 3 Renewz Flammability 0 Reactivity 1 PRODUCT CODES PPI D 82644, 82646, 82650 CHEMICAL FAMILY: Inorganic Base USE Condenser Coil Cleaner MANUFACTURER'S NAME EMERGENCY TELEPHONE NO. The RectorSeal Corporation Chemtrec 24 Hours 2601 Spenwick Drive (800) 424-9300 Houston, Texas 77055 USA DATE OF PREPARATION TECHNICAL SERVICE TELEPHONE NO. August 14, 2002 (800) 231-3345 ============================================================================= Section 2 -- COMPOSITION/INFORMATION ON INGREDIENTS ----------------------------------------------------------------------------- % by WT CAS No. INGREDIENT UNITS 15 1310-73-2 Sodium Hydroxide ACGIH TLV CL 2 mg/m3 OSHA PEL CL 2 mg/m3 2 1312-76-1 Potassium Silicate ACGIH TLV N/D OSHA PEL N/D ============================================================================= Section 3 -- HAZARDS IDENTIFICATION ----------------------------------------------------------------------------- SUMMARY OF ACUTE HAZARDS Exposure to human tissue will result in irritation and chemical burns. ROUTE OF EXPOSURE, SIGNS AND SYMPTOMS INHALATION Extremely corrosive to respiratory system. EYE CONTACT Corrosive, contact causes severe eye burns. SKIN CONTACT Corrosive to skin. INGESTION Poison! Swallowing large quantities can cause death and burns to digestive system. SUMMARY OF CHRONIC HAZARDS Exposure to human tissue will result in irritation and chemical burns. MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE Individuals with pre-existing or chronic diseases of the eyes, skin or persons with chemical sensitivity may have increased susceptibility to excessive exposures. ============================================================================= Section 4 -- FIRST AID MEASURES ----------------------------------------------------------------------------- If INHALED: If overcome by exposure, remove victim to fresh air immediately. Give oxygen or artificial respiration as needed. Obtain emergency medical attention. Prompt action is essential. If on SKIN: Flush with large amounts of water. If irritation or burns occur, seek immediate medical attention. If in EYES: Flush with large amounts of water for at least 15 minutes. Get medical attention if irritation persists. If SWALLOWED: If swallowed, call a physician immediately. Only induce vomiting at the instruction of a physician. Never give anything by mouth to an unconscious person. ============================================================================= Section 5 -- FIRE FIGHTING MEASURES ----------------------------------------------------------------------------- FLASH POINT LEL UEL None N/A N/A EXTINGUSING MEDIA Use agents suitable for surrounding fires. SPECIAL FIRE FIGHTING PROCEDURES: Wear self-contained breathing apparatus (SCBA) and other protective clothing. Hazardous decomposition products possible (see Section 10). Dike area as run-off may create additional environmental contamination UNUSUAL FIRE AND EXPLOSION HAZARDS: Decomposition forms toxic fumes of sodium oxide. Flammable gas may be produced on contact with metals. ============================================================================= Section 6 -- ACCIDENTAL RELEASE MEASURES ----------------------------------------------------------------------------- STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Keep people away. Wear chemical protective clothing. Stop discharge if possible. Isolate and remove discharged material. Flush and clean area with water ============================================================================= Section 7 -- HANDLING AND STORAGE ----------------------------------------------------------------------------- PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Keep container closed and upright when not in use. Store only in polyethylene or glass containers. DO NOT USE METAL CONTAINERS. OTHER PRECAUTIONS: Do not permit workers to handle Renewz without proper training or proper protective equipment. Store in well-sealed containers, which are protected from physical damage. Empty containers may contain residues and vapors; treat as if full and observe all product precautions. Do not reuse container. KEEP OUT OF REACH OF CHILDREN. ============================================================================= Section 8 -- EXPOSURE CONTROLS/PERSONAL PROTECTION ----------------------------------------------------------------------------- RESPIRATORY PROTECTION (SPECIFY TYPE): In confined, poorly ventilated areas, use NIOSH/MSHA approved self-contained breathing apparatus. None required for normal use in adequately ventilated areas where TLV is not exceeded. VENTILATION - LOCAL EXHAUST: Acceptable SPECIAL: Explosion proof MECHANICAL (GENERAL): Preferable OTHER: N/A PROTECTIVE GLOVES: Rubber or neoprene EYE PROTECTION: Chemical splash goggles (ANSI Z-87.1 or equivalent) OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Coveralls recommended. WORK/HYGIENIC PRACTICES: Where use can result in skin contact, wash exposed areas thoroughly before eating, drinking, smoking, or leaving work area. Launder contaminated clothing before reuse. ============================================================================= Section 9 -- PHYSICAL AND CHEMICAL PROPERTIES ----------------------------------------------------------------------------- BOILING POINT: >212 F (>100 C) @ 760mm Hg SPECIFIC GRAVITY (H20 = 1): 1.2 VAPOR PRESSURE (mm Hg): 1 @ 77 F (20 C) MELTING POINT: N/A VAPOR DENSITY (AIR = 1): >1 EVAPORATION RATE (ETHYL ACETATE = 1): <1 APPEARANCE/ODOR: Clear Yellow Liquid/ Little or No Odor SOLUBILITY IN WATER: Soluble ============================================================================= Section 10 -- STABILITY AND REACTIVITY ----------------------------------------------------------------------------- STABILITY: Stable CONDITIONS TO AVOID: Heat, sparks, open flames. INCOMPATIBILITY (MATERIALS TO AVOID): Acids, flammable liquids, organics, halogens, metals, nitromethane. When wet, attacks chemically active metals such as aluminum, tin, lead, and zinc to produce flammable hydrogen gas. HAZARDOUS DECOMPOSITION PRODUCTS: Decomposition forms toxic fumes of sodium oxide. HAZARDOUS POLYMERIZATION: Will not occur. ============================================================================= Section 11 -- TOXICOLOGY INFORMATION ----------------------------------------------------------------------------- CHRONIC HEALTH HAZARDS No ingredient in this product is an IARC, NTP or OSHA listed carcinogen. ----------------------------------------------------------------------------- TOXICOLOGY DATA Ingredient Name ----------------------------------------------------------------------------- Sodium Hydroxide Oral-Rabbit, adult LDLo:500 mg/kg Inhalation-Rat LC50: N/D Potassium Silicate Oral-Rabbit, adult LD50: N/D Inhalation-Rat LC50: N/D ============================================================================= Section 12 -- Ecological Information ----------------------------------------------------------------------------- ECOLOGICAL DATA Ingredient Name ----------------------------------------------------------------------------- Sodium Hydroxide Food Chain Concentration Potential None WATERFOWL TOXICITY N/D BOD None AQUATIC TOXICITY 125 ppm/96 hr/mosquito fish/TLm Potassium Silicate Food Chain Concentration Potential N/D WATERFOWL TOXICITY N/D BOD N/D AQUATIC TOXICITY N/D ============================================================================= Section 13 -- DISPOSAL CONSIDERATIONS ----------------------------------------------------------------------------- Waste Classification: Corrosive(D002) Disposal Method: Neutralization RCRA classified hazardous waste. Dispose of absorbed materials and liquid waste in accordance with all local, state and federal regulations. ============================================================================= Section 14 -- TRANSPORTATION INFORMATION ----------------------------------------------------------------------------- DOT: Sodium Hydroxide, Solution, UN 1824, Class 8, PG II, ERG#154 OCEAN (IMDG): Sodium Hydroxide, Solution, UN 1824, Class 8, PG II, IMDG#8226, EMS#8-06 AIR (IATA): Sodium Hydroxide, Solution, UN 1824, Class 8, PG II, ERG#154 WHMIS (CANADA): Class E ============================================================================= Section 15 -- REGULATORY INFORMATION ----------------------------------------------------------------------------- REGULATORY DATA Ingredient Name ----------------------------------------------------------------------------- Sodium Hydroxide SARA 313 No TSCA Inventory Yes CERCLA RQ 1000 lb. RCRA Code N/A Potassium Silicate SARA 313 No TSCA Inventory Yes CERCLA RQ N/A RCRA Code N/A ============================================================================= Section 16 -- OTHER INFORMATION ----------------------------------------------------------------------------- This document is prepared pursuant to the OSHA Hazard Communication Standard (29 CFR 1910.1200). The information herein is given in good faith, but no warranty, expressed or implied is made. Consult RectorSeal for further information: (713) 263-8001