Condensing unit, air cooled, dual semi-hermetic compressor, extended low temp, R404A, R507, 60 HP, 460/3/60, w/ receiver
Trenton Refrigeration Products
URI Part Number:
Shipping Weight (Lbs.):
Connection Liquid (In.):
Connection Suction (In.):
Receiver Capacity 90 % Full (Lbs.):
WARNING: This product can expose you to chemicals including Lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Compatible with Low GWP Refrigerants
Units are CULUS Listed.
Designed for use with various popular refrigerants.
Energy efficient compressors with POE oil. Several options to choose from: Copeland Discus, Bitzer reciprocating.
Single, dual and parallel-piped (optional) compressor configurations available.
Generously sized condenser allows unit to operate at higher than normal ambient conditions.
Optional coating and fin surfaces for condenser core protection available.
Specially designed, thermally protected and permanently lubricated ball bearing condenser fan motor(s).
Receivers (where used) are liberally sized and include inlet as well as outlet service valves.
Subcooling circuit in condenser on all models (except H8 models) increases overall system efficiency and provides dependable compressor operation.
Utilizes pre-formed internal piping, eliminates welded joints and reduces chances of a leak.
Electrical components are housed in a spacious and conveniently located panel. In case of a compressor trip, (except on air conditioning models) a Lock-out relay de-energizes the liquid line solenoid valve. In addition, SPDT contact is provided for field wired alarm circuit.
End compartment panels allow unrestricted access to service the compressor(s) and all other components.
Raceway for pressure control wiring and connections provides neat appearance.
Units are available with energy efficient ThermosaverTM hot gas defrost option.
Units are environmentally friendly operating on less power and refrigerant charge.
Standard features include:
Spring mount compressor with discharge vibration eliminator
Compressor head cooling fans on low temperature models (except L8 units)
Compressor crankcase heater
Flexible hose on all compressor pressure control connections
Two valve adjustable (pre-set at factory)
Low Ambient head pressure control
Condenser fan cycling control (pressure) on two-fan models and up
Fused condenser fan motors
Receiver inlet/outlet valves and safety pressure relief valve
Replaceable liquid line drier & sight glass
Anti-short cycle time delay relay
Oil failure control (non-electronic)
Separate HP and LP compressor controls
Part-winding start on all 30 HP and up, operating on 208/230V-3Ph
Lock out relay
Sub-cooling circuit on medium and low temperature units