1. Home/
  2. Supplies and Service/
  3. Gases/
  4. Pressurized Gas/
  5. Kit/
  6. MBK6
  View Compare ( 0 )
Log in for pricing and inventory.

MBK6

MBK6
Log in for pricing and inventory
Multigas mini kit, features a 2-1/2 CO/9 cu/ft. nitrogen cylinder and includes VA06 on-off valve, holster, CA250 regulator, HK03 3' hose and blowgun, FA01 nitrogen-CO transfill adaptor, CB03-3/4" cone tip, FA03 transfill connector
Regional Add to Job List
View Catalog Page
Vendor Name:
Diversitech
URI Part Number:
MBK6
Vendor Part Number:
MBK6
Description:
Drain Kat™ Mini Kit for Nitrogen or CO2 with Accessory Fitting Kit
Length (In.):
16.10
Width (In.):
6.80
Height (In.):
6.80
Shipping Weight (Lbs.):
8.20
Includes:
Small cylinder that holds 9 cubic feet of nitrogen or 2-1/2 pounds of CO2; integral mounted regulator. 87” hose and drain gun kit, the CW-15 whip hose, and the AP-DK DrainKatTM Accessory Fitting Kit which contains the DF-75 DrainDawgTM inflatable tip, the CB-03 3/4”-1” cone fitting, the FA-01 male to male CO2 to nitrogen adapter, the FA-03 CO2 trans-fill adapter, and the the QN-S3 needle tip
Prop65:
WARNING: This product can expose you to chemicals including Lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
  • Both the Drain Dawg and the Drain Kat feature an industry leading brass piston regulator with internal bleed down safety.
  • The flexible hose assembly enables you to maneuver through cabinets, coils, and hard to reach drains.
  • The Drain Kat weighs less than 7 pounds, and even includes a free shoulder strap.
  • Drain Kat can be used for many job-site tasks. With a nitrogen fill, you can purge and pressure test copper tube, calibrate pressure controls, clean condensate lines, clean coils, operate air powered tools, and cleanout oil burner lines. With a CO2 fill you can do everything you do with nitrogen except purge and test copper tube or calibrate pressure controls. CO2 should never be used inside the refrigerant pipework.
  • the Drain Kat can supply up to 250 psi.
  • The Drain Kat can be easily refilled at your service truck with either nitrogen or CO2. Adapters and fittings are included with Drain Kat. Stop lugging heavy cylinders around the job-site, use the 2-1/2 pound refillable cylinder in the Drain Kat.
  • A simple plastic compartmented box is supplied with each Drain Dawg and Drain Kat. This box contains all of the adapters, fittings, and nozzles that you need for maximum effectiveness.
  • Drain Dawg and Drain Kat both come complete with the unique Drain Dawg inflatable tip. This tip fits 3/4" or 1" drain pipes and once charged with nitrogen or CO2, expands and seals against the inside wall of the pipe, directing pressure discharge down the pipe to blow out any clog.
  • Both the Drain Kat and the Drain Dawg can be used with either nitrogen or CO2. Nitrogen is easy to fill and commonly available, while a CO2 cylinder will last longer. The Drain Gun should be used only with DiversiTech brand CO2 cartridges.
Substitutes Documents